![]() Please help, as now I'm stuck in recovery mode and keep getting an error -1 after the phone reaches the final "updating iPhone baseband" step in the update. If the baseband chip is damaged, then how come it works? It's version is 3.0.4, I think. I have restored my phone 23 times since then-but out of those, only 3 were successful in getting back my signal-and then I lose it again if I charge my phone via charger or PC. I figured there's something wrong with the baseband chip, but then I tried restoring via redsn0w to iOS 6.0.1-and after the restore, the phone worked again. I can't see my IMEI number, and my modem firmware is blank. I tried restoring the phone, but it gives me error -1, in the about section. After that, the phone displayed "searching" again. This fixed my problem for a couple of weeks. After an extensive search on the internet, I upgraded to iOS 6.0.1. If you have a backup created then you can Restore Your iPhone from that backup file. You will need a computer for this task and all your data on your iPhone will be wiped clean in the process. It worked fine for a few months, until one day I left it charging through the night and woke up to find the phone stuck in "searching" mode. You can reset your passcode by following the instructions in this article by Apple How to reset your passcode on a disabled iPhone. ![]() You only need one Apple ID for everything you do with Apple.Īlso, and iTunes account and an Apple ID are the same thing.I have a huge problem. If you don’t already have an Apple ID, you can create one whenever you’re asked to sign in. ![]() If you already have an Apple ID, use it when you first set up iPhone, and whenever you need to sign in to use an Apple service. Your Apple ID is the account you use for just about everything you do with Apple, including storing your content in iCloud, downloading apps from the App Store, and buying music, movies, and TV shows from the iTunes Store. Turning on recommended features such as Location Services.Signing in with or creating a free Apple ID (needed for many features, including iCloud, FaceTime, the App Store, the iTunes Store, and more).The Setup Assistant steps you through the process, including: Turn on iPhone and follow the Setup Assistant. If neither option is available, you need to connect iPhone to your computer and use iTunes to activate iPhone (see Connect iPhone to your computer). WARNING: To avoid injury, read Important safety information before using iPhone.Īctivation can be done over a Wi-Fi network or, with iPhone 4s or later, over your carrier’s cellular network (not available in all areas). iTunes will alert you that it has detected a device in recovery mode.Continue holding the Home button until you see the Connect to iTunes screen.While pressing and holding the Home button, reconnect the USB cable to the device.Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider.You can try to remove the battery and insert it again in your iPhone or. Disconnect the USB cable from the device, but leave the other end of the cable connected to your computer's USB port. Sometimes damaged battery or damaged USB port can also cause iPhone 4s error 11.If you have been using iCloud to back up, you may be able to restore the most recent backup to reset the passcode after the device has been erased.Īlternatively, place the device in recovery mode and restore it to erase the device: If you have Find My iPhone enabled, you can use Remote Wipe to erase the contents of your device. "You haven't chosen to have trust this computer" You must enter your passcode on the before it can be used with iTunes." "iTunes could not connect to the because it is locked with a passcode. If you see one of following alerts, you need to erase the device: If you have never synced your device with iTunes, or you do not have access to a computer
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |